Kohler K-3554-RA-0 Guia de Instalação descarregar pdf (Página 8)

Service – Adjust Gap

If the toilet does not activate, the gap between the actuator and the plunger arm may

need to be reset.

Reset

Make sure the trip lever handle is installed, and the nut on the trip lever is tight.

This is a left-hand thread; turn counterclockwise to tighten.

Make sure the water supply is on and the supply line water has stopped ﬂowing

into the toilet.

Loosen the setscrew, then turn the actuator until there is a 1/16″ (2 mm) - 1/8″ (3

mm) gap between the actuator and the plunger arm. Turn the actuator clockwise

to increase the gap.

Retighten the setscrew after the gap is properly adjusted.

NOTICE: If the plunger is not sealing properly, loss of gap clearance adjustment

could cause leakage into the toilet bowl. This condition could cause a continual ﬂow

of water. If the problem is not corrected after adjustment, refer to the

″Troubleshooting″ section.

Setscrew

Vis de retenue

Tornillo de fijación

Plunger Arm

Bras du plongeur

Brazo del émbolo

Air Inducer

Inducteur d'air

Inductor de aire

1/16" (2 mm) – 1/8" (3 mm) Gap

Espace de 1/16" (2 mm) –

1/8" (3 mm)

Separación de 1/16" (2 mm) –

1/8" (3 mm)

1115561-2-B 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Kohler K-3554-RA-0 Guia de Instalação Página 8