Kohler K-R45783-4-BN Guia de Instalação Página 2

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 20
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 1
Tools/Outils/Herramientas
Important Information
CAUTION: Risk of personal injury. If the water temperature is set too high,
scalding will occur. The water temperature should never be set above 120°F
(49°C).
NOTICE: Risk of product damage. Do not force the handle in any direction. Forcing
the handle will damage the valve.
NOTICE: Risk of product damage. Long screws, for installing trim, can damage the
K-2971-KS valve. When using this valve and trim with wall thicknesses less than
13/16 (21 mm) thick, use the 88526 Thin Wall Installation Kit.
NOTICE: Choose an automatic compensating valve with the appropriate minimum
flow rating to assure your valve will provide safety at the lowest flow rates:
For a showerhead rated at 2.0 gpm (7.6 L/min) maximum and 1.6 gpm (6.1
L/min) minimum, use with an automatic compensating valve rated at 1.6 gpm
(6.1 L/min) or less.
For a showerhead rated at 2.5 gpm (9.5 L/min) maximum and 2.0 gpm (7.6
L/min) minimum, use with an automatic compensating valve rated at 2.0 gpm
(7.6 L/min) or less.
Observe all local plumbing and building codes.
The finished wall or bath/shower unit must be installed prior to installing the
trim.
If the wall thickness is greater than 3/4 (19 mm) a deep rough-in kit is required.
Use Deep Roughing-in kit 1073881.
NOTE: For service parts information, visit your product page at www.kohler.com.
Informations importantes
ATTENTION: Risque de blessures. Des brûlures peuvent se produire si la
température de l’eau est trop élevée. La température de l’eau ne doit jamais être
réglée à une température supérieure à 120°F (49°C).
NOTICE: Risque d’endommagement du produit. Ne pas forcer la poignée dans une
direction quelconque. La vanne subira des dommages si la poignée est forcée.
Plumbers Putty
Mastic de plombier
Masilla de plomería
Silicone Sealant
Joint en silicone
Sellador de silicona
Sealant Tape
Ruban d'étanchéité
Cinta selladora
Strap Wrench
Clé à sangle
Llave de correa
Plus/Plus/Más:
• 1/2" Copper Tube or Nipple
Tube ou mamelon en cuivre 1/2" NPT
Tubo de cobre o niple de 1/2" NPT
• Rags/Chiffons/Trapos
• Emery Paper/Papier émeri/Papel lija
1/8"
1183592-2-B 2 Kohler Co.
Vista de página 1
1 2 3 4 5 6 7 ... 19 20

Comentários a estes Manuais

Sem comentários