Kohler Aegis TP-2509 Manual do Utilizador descarregar pdf (Página 18)

2.2

Section 2

Special Tools

Special Tools You Can Make

Flywheel Holding Tool

Flywheel removal and reinstallation becomes a ‘‘snap’’

using a handy holding tool you can make out of a

piece of an old ‘‘junk’’ flywheel ring gear as shown in

Figure 2-2. Using an abrasive cut-off wheel, cut out a

six tooth segment of the ring gear as shown. Grind off

any burrs or sharp edges. The segment can be used in

place of a strap wrench. Invert the segment and place

it between the ignition module bosses on the #1

cylinder so that the tool teeth engage the ring gear

teeth on the flywheel. The bosses will ‘‘lock’’ the tool

and flywheel in position for loosening, tightening, or

removing with a puller.

Figure 2-2. Flywheel Holding Tool.

RTV Silicone Sealant

RTV (Room Temperature Vulcanizing) silicone sealant

is used as a gasket between the crankcase and oil

pan.

Only oxime-based, oil resistant RTV sealants, such as

those listed below, are approved for use. Loctite

Nos.

5900 and 5910 are recommended for best sealing

characteristics.

Loctite

Ultra Blue 587

Loctite

Ultra Copper

Loctite

Ultra Black 598

Loctite

5900 (Heavy Body)

Loctite

5910

NOTE: Always use fresh sealant. Using outdated

sealant can result in leakage.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 136 137

Sem comentários

Kohler Aegis TP-2509 Manual do Utilizador Página 18